3D Printed Prototype Compact Bundle Silver
Out of stock
This prototype has many components actually used in the Kickstarter campaign and should be considered as used and different from the short run production units. The compact panel itself was used in the campaign video and does not have the hole pre-drilled for flipper clapper use. It also does not have the required hole on the front panel to power front lit LEDS, but the contact pins are functional on the enclosure itself. The housing has been replaced with a new 3D Printed housing. Material used for the enclosure is ABS Plastic.
The photos above is of the actual unit you will be receiving. The FDC Generator Display will arrive already installed in the compact panel.
•1/4" TRS Input/Output
•Standard 5-pin Lemo Input/Output
•Button to view last clapped time
•Easy access brightness knob
•Uses four "AA" Batteries
•Easy navigation button to setup time and user data
•USB allows for potential firmware updates
•External DC power accepts 5-16V
•Power and low battery indicator
•Weatherproof (IP55) comes as standard*
•Solid Wood Clapper
•Steel Powder coated panel
•1/4" Neutrik Plug
•5-Pin I/O Plug
•Anti-Glare display protector (preinstalled)
•Screw Eyebolt for Wood
*To obtain full seal we highly recommend you use a screw driver to tighten the battery compartment thumb screws.
|Frame Rates||23.976, 24, 25, 29.97, 29.97 Drop, 30, 30 Drop|
|Input/Output||1/4" Phono TRS, Standard 5-Pin Lemo|
|Dimensions||8.5"W x 6.5"H x 1.5"D|